The workings of a garage door are pretty simple and straightforward. All it does is go up and down every day until one day it stops working. Fortunately, as simple as the garage door’s functionalities is, its repair is relatively simple as well. However, there might be some garage doors that are quite old and needs significant repairs. Suppose you suspect that yours need a major repair or you have a busy life schedule that disables you to maintain and look after your home’s garage door. In that case, it will be in your best interest to call Garage Door Repair Lawrenceville services to do the job for you.
To prevent significant problems in your garage doors and keep them working for more extended periods, here are five simple tips to help you do so.
Table of Contents
Tighten the Hardware
Over time, the hardware of the garage doors might become loose and thus fail to function correctly. For instance, on an overhead garage door, its rollers are guided by tracks built in several sections. These sections are attached to the garage with the help of brackets. Make sure that the screws and bolts which are holding these brackets down are tight and secure. Check for these screws and bolts in your garage door and see if they are tightened or not. Bring out your trusty wrench and pull it once in a while to ensure the proper functioning of them.
Check the tracks and the rollers
Clean the tracks on which the rollers move and ensure that they are free of any debris, twigs, dead leaves, and peoples. You can effectively clean them with a brush and dust away all the trash. As for your rollers, clean them and lubricate them. Do not forget to lubricate the axles as well. If you see any worn-out rollers which are not working correctly, consider replacing them yourself or with the help of Garage Door Repair Sandy Springs services.
Test the balance of the Garage door
A properly working garage door needs just a bit of pressure to move it up and down. If it needs a considerable amount of more pressure, it means that the springs have worn out and have lost their resiliency. This is especially bad for the doors which are lifted via a power garage door opener. If the door needs extra pressure, this means that the opener’s motor will wear out more quickly. If you suspect that your door is not closing and opening correctly, call a Garage Door Repair Sandy Springs service and replace the worn-out springs with their help.
Check the pulleys and the cables of the door
Most common garage doors that are operated by springs have several pulleys and cables. These pulleys and cables wear out over time and need to be repaired or replaced. If you think that the wires and pulleys in your garage door are frayed, contact Garage Door Repair Lawrenceville services to replace them immediately.
Test the autoreverse feature in your garage door
The last tip to make sure that your garage door is functioning correctly is to test its autoreverse feature. This feature is generally found in most garage door openers where if the door faces an obstacle while closing, it automatically stops and goes back and lifts the door. If this feature stops working, it can be very hazardous. Repair or replace the opener immediately if you find this feature not working.
These were some of the tips that will help you counter common garage door problems such as noisy garage doors and faulty openers.
